A Simple Plan: Equipment
Posted On July 24, 2019
The Advantages That You Can Get From Water Jet Cutting Systems
The 5 most renowned benefits of water jet cutting systems
If you have already manufactured with the water jet cutting systems or is still starting to get a head start for it, you should be able to know all of the benefits that it is going to give you. Before making any decision, you should make your own research first and the same goes with the water jet cutting equipment which is able to provide you a lot of advantages, however, you need to read more here to get more information.
Abrasive waterjet cutting, as well as pure waterjet cutting, are the two kinds of methods that exist in the waterjet technology. When you are going to cut soft materials such as paper or foam, it would be best to use the pure waterjet cutting method where only water stream is used for cutting. This is in contrast with the abrasive waterjet cutting method wherein a granular abrasive needs to be added in the water stream. It is the job a the granular abrasive to accelerate the power that the cutting stream holds so that hard materials will easily be cut such as ceramics or metal.
If you want to increase your knowledge about the waterjet technology, here are five benefits that will help you with it:
1. The waterjet technology is applicable to almost every material so there is no limitation
Almost all kinds of materials are being cut by the waterjet technology including rubber, rock or stone, ceramics, plastics, composites, and metals. The waterjet cutting systems will be able to perform better if a granular abrasive is being added since it will be able to cut materials up to a 200mm thickness.
2. You do not have to worry about the HAZ or the heat affected zone
The HAZ or the heat affected zone should be less of your worries since the water jet cutting equipment is made up of a cold cutting method. There is no need for you to think about the risks of burns anymore since the cold cutting makes sure to enable clean cuts and keeps the safety of the operator significantly.
3. Materials are not being distorted
There is no need for you to worry that the material will be deformed especially if it is a hard one such as metal, because the cold cutting method makes sure that any heat exposure will be taken care of. A burr-free cut, as well as a smooth finish, will be the result from this.
4. This particular method will not make you do some finishing process to your product.
The products will be provided with the highest cutting quality with accurate results that is why you do not need to worry about any finishing process that you might need to apply.
5. No need to worry about any hazardous waste
There is apparently a growing importance of a friendly environmental process in the industry these days.
Where To Start with Waterjets and More
Figuring Out Waterjets